User Manual v1.0_EN

112
8 protocols are available: CAN High, CAN Low, LIN, FlexRay, RS232/UART, I2S,
I2C, and USB (1.0/1.1). The detailed setting options vary by each protocol.
 CAN High / CAN Low: Controller Area Network (CAN) is a serial protocol used
in automotive to allow microcontrollers to communicate with each other. It
typically uses differential signaling (with signals named CAN High and CAN
Low) to increase noise immunity.
 LIN: Local Interconnect Network (LIN) is a serial protocol used in automotive
electronics to allow microcontrollers to communicate with low-speed
peripherals.
 FlexRay: It is an automotive network communications protocol for high-speed
data.
 RS232/UART: Universal Asynchronous Receiver/Transmitter (UART) is the
communication interface found in the serial or COM ports once commonly
found on computers. Each channel of data is transmitted on a single wire pair
using an electrical standard such as RS232.
 I2S: Inter-IC Sound (I2S) is a serial protocol used in digital audio devices for
communications between circuits such as CD transports and audio DACs.
 I2C: Inter-Integrated Circuit (I2C) is a way to connect peripheral chips in
consumer electronics products and is widely used in embedded systems.
 USB (1.0/1.1): Universal Serial Bus (USB) is widely used in personal
computers and tablets for communication.
Baud Rate: The baud rate will display a default value, which needs to be manually
set according to the actual signal to get the correct decoding result.
Threshold: The voltage that defines the transition in either direction between high
logic state and low logic state.