User Manual v1.0_EN

135
 X1: no attenuation
 10∶1 Attenuator: select when using a 10-fold attenuation probe
 20∶1 Attenuator: select when using a 20-fold attenuation probe (SA020)
 X1000: select when using a 1,000-fold attenuation probe
 65A Current Clamp (1mV/10mA mode, Max: 20A): 1mV/10mA mode on 65A
current clamp, the max. current is 20A
 65A Current Clamp (1mV/100mA mode, Max: 65A): 1mV/100mA mode on
65A current clamp, the max. current is 65A
 650A Current Clamp (1mV/100mA mode, Max: 200A): 1mV/100mA mode on
650A current clamp, the max. current is 200A
 650A Current Clamp (1mV/1A mode, Max: 650A): 1mV/1A mode on 650A
current clamp, the max. current is 650A
 Coil-On-Plug Ignition Probe [COP]: select when using the COP ignition probe
(SA271)
 Secondary Ignition Probe [ignition]: select when using the secondary ignition
probe (SA273)
 Secondary Ignition Probe (inverted) [R_ignition]: select when using the
secondary ignition probe (SA273) and inverting the secondary ignition signal
You can select the inner standard probes in the probe settings. After selecting a
correct probe, the settings can be seen in the lower right corner of the left column of
the channel control button, indicating the probe is in use.
Tap the question mark icon to view the image of the corresponding current clamp in
full screen.