User Manual v1.0_EN

143
NOTE
The oscilloscope switches to the continuous mode if the time base is set to more
than or equal to 200ms/div. The Edge Triggering is supported in the continuous
mode.
 Trigger Mode
Four trigger modes are available: None, Auto, Repeat and Single.
Figure 7-66 Sample Trigger Mode Screen
The table below offers brief descriptions for each trigger mode.
Table 7-6 Trigger Mode Table
Trigger Mode
Description
None
In this trigger mode, the oscilloscope can continuously capture
data, without waiting for a trigger event.
Auto
In this trigger mode, the oscilloscope will wait for a trigger before
capturing data. It can automatically update after a short period,
even if the signal does not across the trigger point.
Repeat
In this trigger mode, the oscilloscope waits until a trigger event
occurs. If there is no trigger event, nothing will be displayed on
the screen.
Single
In this trigger mode, the oscilloscope stops capturing data once
a trigger event occurs.
 Channel