User Manual v1.0_EN

154
 Fall Time – the time the signal takes to fall from the upper threshold to the
lower threshold
 X@Max – the corresponding value of X axis when the amplitude is the
maximum
 X@Min – the corresponding value of X axis when the amplitude is the
minimum
 Positive Acreage – the waveform acreage measured above the zero baseline
 Negative Acreage – the waveform acreage measured below the zero
baseline
 Full Acreage – the positive acreage plus negative acreage
 Top Value – 90% of the waveform maximum value
 Bottom Value – 10% of the waveform minimum value
 Positive Overshoot – the ratio of the difference between the maximum value
and the top value and the amplitude
 Negative Overshoot – the ratio of the difference between the bottom value
and the minimum value and the amplitude
 Positive Pre-shoot – the ratio of the difference between the bottom value and
the minimum value and the amplitude
 Negative Pre-shoot –the ratio of the difference between the maximum value
and the top value and the amplitude
NOTE
When connecting via Wi-Fi，it only supports Maximum, Minimum, Peak To Peak,
Amplitude, Period, Frequency, Positive Duty Ratio, Negative Duty Ratio, Positive
Pulse Width, Negative Pulse Width, AC RMS, True RMS, DC Average, X@Max,
X@Min, Top Value and Bottom Value.
In the Spectrum View, the available measurements are as follows.