Manualshelf

User Manual v1.0_EN

ManualsBrandsAutel ManualsAutomotiveMaxiSys MS919
251252253254255256257258259260
253
10. To disconnect the device, tap the connected device listing again.
11. Tap Back on the top left to return to the MaxiSys Job Menu.
NOTE
To ensure quick connection, please perform this operation in a steady network
environment.
11.2 BT Pairing
BT Paring is the basic way for wireless connection. The VCMI device needs to be either
connected to a vehicle or to an available power source, so that it is powered up during
the synchronization procedure. Make sure the tablet has a charged battery or is
connected to an AC/DC power supply.
Figure 11-2 Sample BT Pairing Screen
To pair the VCMI device with the tablet
1. Power on the tablet.
2. Connect the 26-pin end of the data cable to the VCMI's vehicle data connector.
3. Connect the 16-pin end of the data cable to the vehicle data link connector
(DLC).
4. Tap VCMI Manager on the MaxiSys Job Menu of the tablet.
5. Select BT, short for Bluetooth, from the connection mode list.
6. Swipe the Bluetooth toggle button to ON. Tap Scan at the top right corner. The
device will start to search for available pairing units.
7. Depending on the VCMI type you use, the device name may display as Maxi