User Manual v1.0_EN

47
4) Parameter – automatically triggers data recording when any parameter value
reaches the preset threshold.
b) Duration – sets the recording duration (for Auto trigger mode only).
c) Trigger point – reserves a relative percentage of a record length before the data
recording start point for reference (for Auto trigger mode only).
 To perform setting for live data record
1. Tap the Setting button at the bottom of the Live Data screen.
2. Tap the Record navigation button.
3. Tap the button to the right of Trigger type and select the required trigger mode.
4. Tap the button to the right of Duration and select the time duration.
5. Tap the button to the right of Trigger point and select a relative percentage of
a record length to be reserved before the data recording start point.
6. Tap Done to save the setting and return to the Live Data screen; or tap Cancel to
exit without saving.
 Done – confirms and saves the setting, and redirects you to the Live Data screen.
 Cancel – cancels the setting operation, and redirects you to the Live Data screen.
4.8 Active Test
The Active Test function is used to access vehicle-specific subsystem and component
tests. Available tests vary by vehicle.
During an active test, the tablet sends commands to the ECU to activate the actuators.
This test determines the integrity of the system or part by reading ECU data, or by
monitoring the operation of the actuators. Such tests may include switching a solenoid,
relay, or switch, between two operating states.
Selecting Active Test displays a menu of test options. Available tests vary by vehicle.
Select test from menu option. Follow the instructions displayed on screen to complete
test. Procedures and instructions vary by vehicle.