Manual

3) Once the sensor IDs are successfully written, a confirm screen

will show up. Press any key to continue the TPMS diagnostic

procedure. (Figure 4.24)

Figure 4.24

NOTE: The sensor writing procedure may vary for different

vehicles being serviced. Please follow the onscreen instruction

and take appropriate measures and selections to complete the

process.

NOTE: If there are untested sensors in the vehicle, the writing

ID process cannot proceed. The tool will display a warning

message as below.(Figure 4.25) In this case, follow the sensor

check procedure to activate all sensors in vehicle and register

sensor IDs again.

Figure 4.25

IMPORTANT: Make sure to turn the ignition off before connecting

/disconnecting the OBDII Cable to/from the TPMS tool; otherwise

it may cause the Malfunction Indicator Light (MIL) to turn on.