Full Product Manual

On-Board Monitor

Use this option to view the results of On-Board Monitor tests. The tests are

useful after servicing or after erasing a vehicle’s control module memory.

Component Test

This service enables bi-directional control of the ECM so that the diagnostic

tool is able to transmit control commands to operate the vehicle systems. This

function is useful in determining whether the ECM responds to a command well.

Vehicle Information

The option displays the vehicle identification number (VIN), the calibration

identification, and the calibration verification number (CVN), and other

information of the test vehicle.

Vehicle Status

This option is used to check the current condition of the vehicle, including

communication protocols of OBD II modules, retrieved codes amount, status

of the Malfunction Indicator Light (MIL), and other additional information.

Exiting Diagnostics

The Diagnostics application remains open as long as there is an active

communication with the vehicle. You must exit the diagnostics operation

interface to stop all communications with the vehicle before closing the

Diagnostics application.

NOTE: Damage to the vehicle electronic control module (ECM) may occur if

communication is disrupted. Make sure all connections, such as data cable and

USB cable, are properly connected at all times during testing. Exit all tests

before disconnecting the test cable or powering down the tool.

 To exit the Diagnostics application

1. From an active diagnostic screen, tap the Back or ESC functional

button to exit a diagnostic session step-by-step; Or

2. Tap the Vehicle Swap button on the diagnostics toolbar to return to

the Vehicle Menu screen.

3. From the Vehicle Menu screen, tap the Home button on the top