Manualshelf

User Manual

ManualsBrandsAutel ManualsAutomotiveMaxiSys MS919 Automotive Diagnostic Tool, Advanced Intelligent Diagnostics for Diagnostic Technician, 5-in-1 VCMI, TSB, Repair Assist/Tips, Module Topology, Bi-Directional Control(US IP ONLY)
151152153154155156157158159160
147
Figure 7-64 Sample Trigger Point Screen
When the oscilloscope is capturing the signal, tap the right column of the Trigger
button to open the trigger settings dialog box.
Figure 7-65 Sample Trigger Settings Screen
Edge Triggering
The edge trigger is one of the most common trigger modes and is activated when
voltage rises above or falls below a preset threshold. This trigger type allows you to
configure the trigger mode, threshold, trigger channel and pulse direction settings.
Tap Done to save the settings or tap Cancel to exit without saving.
NOTE
The oscilloscope switches to the continuous mode if the time base is set to more
than or equal to 200ms/div. The Edge Triggering is supported in the continuous
mode.
Trigger Mode
Four trigger modes are available: None, Auto, Repeat and Single.