User Manual

168
 Do not add voltage to the input terminal when measuring resistance.
 To avoid electric shock, turn off the power to the component before connecting.
 To prevent damage, always use and store your multimeter in appropriate
environments.
 Do not use in wet or damp conditions, or around explosive gas or vapor.
 Do not tamper with or disassemble the multimeter, connectors or accessories.
Internal damage will affect performance.
 Before carrying out maintenance and cleaning of the multimeter, make sure the
unit is NOT connected to a power source, vehicle or computer.
 When cleaning the multimeter, use a damp, soft cloth with mild detergent. Do not
allow water to enter the multimeter casing.
7.2.2 General Introduction
7.2.2.1 Component Locations
The multimeter jacks are located on the top of the VCMI device while the input
channels are located at the bottom.
VCMI Top View
1. Multimeter Jacks – for ground and signal cables
2. USB Port
3. Hook
4. DC Power Supply Input Port
5. Power Button
IMPORTANT
When using the multimeter function, please insert the supplied multimeter probes to
the multimeter probe jacks. When measuring the current, use a current clamp to
connect to the input channel A on the top of the VCMI device.
The multimeter LED is located on the front panel of the VCMI device. When the VCMI
is properly connected and powered on, the multimeter LED lights green when
operating in the multimeter mode.