User Manual

229
Tap the View Waveform button in the lower corner of the Indicator Mode screen to
switch to the Waveform Mode. The screen is shown as below.
Figure 7-13 Sample Waveform Mode Screen
Main View Section
The main view section features as a coordinate grid with X-axis and Y-axis, representing
the time duration and amplitude level respectively. The amplitude level can be configured
in the Amplitude Settings and the time duration can be set in the Time Base Settings.
Channel Selection
Each channel has two conditions: selected and unselected. Some operations depend on
the selected condition of the channel, such as measurement rulers, waveform
movements and waveform zooming.
 To select and unselect the channel
1. Tap the zero baseline marker or the Y-axis (the line thickens when selected).
2. Tap the zero baseline marker or the Y-axis again to exit the channel selection.
Waveform Zooming
The zooming function allows you to change the size and position of a signal during or
after capturing a waveform to examine. It does not change the stored data, only the way
it displays.
The X-axis and Y-axis can be zoomed using your fingertips. The waveform can be
zoomed during or after capturing the signal.
Measurement Rulers