Manualshelf

User Manual

ManualsBrandsAutel ManualsAutomotiveMaxiSys MS919 Automotive Diagnostic Tool, Advanced Intelligent Diagnostics for Diagnostic Technician, 5-in-1 VCMI, TSB, Repair Assist/Tips, Module Topology, Bi-Directional Control(US IP ONLY)
21222324252627282930
20
located under the vehicle dash.
NOTE
The vehicle's DLC is not always located under the dash; refer to the user manual of the
test vehicle for additional connection information.
Non-OBD II Vehicle Connection
This type of connection requires both the main cable and a required OBD I adapter for
the specific vehicle being serviced.
There are three possible conditions for Non-OBD II vehicle connection:
DLC connection supplies both communication and power.
DLC connection supplies communication and power is to be supplied via the
cigarette lighter connection.
DLC connection supplies communication and power is to be supplied via connection
to the vehicle battery.
To connect to a Non-OBD II Vehicle
1. Connect the main cable's female adapter to the Vehicle Data Connector on the
VCMI device, and tighten the captive screws.
2. Locate the required OBD I adapter and connect its 8-pin jack to the main cable's
male adapter.
3. Connect the attached OBD I adapter to the vehicle's DLC.
NOTE
Some vehicles may have more than one adapter or may have test leads instead of an
adapter. Make the proper connection to the vehicle's DLC as required.
To connect the cigarette lighter
1. Plug the DC power connector of the cigarette lighter into the DC power supply
input port on the device.
2. Connect the male connector of the cigarette lighter into the vehicle's cigarette
lighter receptacle.
To connect the clipper cable
1. Connect the tubular plug of the clipper cable to the male connector of the
cigarette lighter.