User Manual

Large Dolphin Clips (Red: SA059, Black: SA060)

Used to connect exposed wires or terminals, including battery

terminals. SA057 (red) and SA058 (black) for smaller

terminals.

Attenuators 20:1 (SA020)

Passive 20:1 attenuator, can output 1V when inputting a 20V

signal.

Battery Clip (Optional) (Red: SA061, Black: SA062)

Dedicated to connecting car battery terminals.

65A AC/DC Current Clamp (Optional) (SA253)

Used to measure AC or DC currents up to 65A. Two scales

are available: 1mV/10mA for 10mA to 20A, 1mV/100mA for

10mA to 65A.

650A AC/DC Current Clamp (Optional) (SA256)

Used to measure AC or DC currents up to 650A. Two scales

are available: 1mV/100mA for 100mA to 200A, 1mV/1A for

100mA to 650A.

Coil On Plug (COP) Probe (Optional) (SA271)

Used with the oscilloscope to measure the secondary ignition

voltage of COP.

HT Extension Lead (Optional) (SA275)

Fit the HT extension leads between the coil pack and the plugs

of the independent ignition system (COP), and then place the

(SA273) secondary ignition pickup on each lead to obtain the

secondary ignition voltage.