Users Manual Part 3

146
 Rising Rate – the rate at which the signal level rises
 Falling Rate – the rate at which the signal level falls
 Rise Time – the time the signal takes to rise from the lower threshold to the
upper threshold
 Fall Time – the time the signal takes to fall from the upper threshold to the
lower threshold
 X@Max – the corresponding value of X axis when the amplitude is the
maximum
 X@Min – the corresponding value of X axis when the amplitude is the
minimum
 Positive Acreage – the waveform acreage measured above the zero
baseline
 Negative Acreage – the waveform acreage measured below the zero
baseline
 Full Acreage – the positive acreage plus negative acreage
 Top Value – 90% of the waveform maximum value
 Bottom Value – 10% of the waveform minimum value
 Positive Overshoot – the ratio of the difference between the maximum value
and the top value and the amplitude
 Negative Overshoot – the ratio of the difference between the bottom value
and the minimum value and the amplitude
 Positive Pre-shoot – the ratio of the difference between the bottom value
and the minimum value and the amplitude
 Negative Pre-shoot –the ratio of the difference between the maximum value
and the top value and the amplitude
 To set the measurements
1. Tap the Measure button at the bottom of the screen to open the
measurement dialog box.
2. Select the channel to be measured.
3. Select the appropriate measurement options. The Whole Track and Ruler
Track can be toggled through the Edit icon in the upper corner of the option.