Users Manual Part 3

203
8.4.2 General Introduction
8.4.2.1 Component Locations
The main connectors are located on the bottom of the VCMI device.
1. Ethernet Connector
2. Vehicle Data Connector
3. Input Channel A
4. Input Channel B
5. Input Channel C
6. Input Channel D
8.4.3 Getting Started
Before opening the OBDII Communication Line Inspection application, you have to
complete three steps below:
1) Connect the VCMI device to the Tablet via Wi-Fi or the supplied USB, see Establish
Vehicle Communication on page 20.
2) Connect the VCMI device to the vehicle’s OBDII connector.
3) Place the ignition in the key on position.