Users Manual Part 4

247
Figure 12-3 Sample BT Pairing Screen
 To pair the VCMI device with the tablet
1. Power on the tablet.
2. Connect the 26-pin end of the data cable to the VCMI’s vehicle data
connector.
3. Connect the 9-pin end of the data cable to the vehicle data link connector
(DLC).
4. Tap VCMI Manager on the MaxiSys Job Menu of the tablet.
5. Select BT, short for Bluetooth, from the connection mode list.
6. Tap the Bluetooth toggle to turn it ON. Tap Scan at the top right corner. Now
the device starts searching for available pairing units.
7. Depending on the VCMI type you use, the device name may display as Maxi
suffixed with a serial number. Select the required device for pairing.
8. When paired successfully, the connection status displays as Connected.
9. Wait a few seconds, and the VCMI button on the system Navigation bar at the
bottom of the screen displays a green check mark, indicating the tablet is
connected to the VCMI device.
10. To disconnect the device, tap the connected device listing again.
11. Tap Back on the top left to return to the MaxiSys Job Menu.
NOTE
A VCMI device can be paired to only one tablet at a time, and once it’s been paired, the
device will not be discoverable for any other unit.