User's Manual

66
66
6
CC
CC
C
ONTROLSONTROLS
ONTROLSONTROLS
ONTROLS
ANDAND
ANDAND
AND
C C
C C
C
ONNECTIONSONNECTIONS
ONNECTIONSONNECTIONS
ONNECTIONS
Your motion activated camera turns on whenever someone approaches your
home and also turns on the connected floodlights to light up the area that the
camera sees. The camera transmits its picture and sound to a 2.4 GHz
receiver (sold separately) which you connect to your TV. Open the lid on the
underside of the motion activated camera to reveal the controls below.
A
CO
ME
G
I
K
A
DUSK CONTROL
CHANNEL
C
B
D
TIME DELAY
UNIT CODE
UNIT CODE
HOUSE CODE
1
315
13 5
7
9
11
LIGHT
MAX.
DARK
MIN.
+
1
You set the channel switch (A, B, C, or
D) to match the setting on the receiver.
When the camera turns on it
transmits a wireless Radio
Frequency (RF) command to
turn off other cameras in a
group of 4 (requires an X10
Transceiver (sold separately).
The setting on these dials sets
the Housecode and Unit Code
for this camera.
You can set it to detect
motion at all times or only
when it gets dark.
The camera turns
off a short time
after motion has
stopped (adjusted
by this dial).
You can turn the floodlights and
the camera on from other X10
remote controls that plug into
any outlet anywhere in your
home. You set the Housecode
dial to the same letter you set on
your X10 controller, and you set
the Unit Code to a number
between 1 and 16.