User's Manual

2524
LEARN
SETUP
All Lts on
CH
+
TOP FINDEND
SCAN
SCAN
+
F. FPLAYREW
PAUSESTOPREC
CH
VOL
PLAYING
ALBUM
SELECT
VOL+
M
1 2
5
8
0
ABC
JKL
TUV
3
6
9
A/B
DEF
MNO
WXYZ
4
GHI
Add
Delete
GENRE
TRACK
ARTIST
AUDIO
TV
PC
X10
on
off
brt
dim
PAG E
DOWN
PQRS
7
TE
ENTER
PLAYLIST
PAG E
UP
CBL
FINE TUNING YOUR SYSTEM
The Lola Wireless Audio/Video Sender usually works best with the flat
faces of the antennas on the Sender and Receiver units facing each other
(see diagram below). Sometimes, however, reflections and other effects in
your home may affect the signal so that some adjustment of either the
Sender or Receiver antenna might be necessary to get the best signal.
IF YOU ARE NOT GETTING ANY SIGNAL AT ALL:
Check that the CHANNEL slide switch (labeled A, B, C, D) on both units
is set to the same letter.
IF THE SIGNAL IS POOR, OR IF THERE IS INTERFERENCE:
Try changing the channel on both units. Do this by adjusting the CHANNEL
slide switch on each unit to any position from A to D. Make sure both units
are set to the same channel.
RECEIVER
TRANSMITTER
Point antennas at each other
Changing the House Code for the Remote
The Remote comes set to House Code A by default. To change the House
Code on the remote follow steps 1 through 4 below:
1. Press and release the
X10 button (indicator
flashes).
2. Press and hold Setup
until the indicator
lights steadily.
Release the Setup
button.
3. Use the number
buttons to enter the
number equivalent to
the chosen
Housecode (1=A,
2=B....16=P). Press 1
then 6 for 16, etc.
4. Press the Mute
button to confirm the
Housecode. The
indicator blinks then
goes off.
Changing the Master Code for the Remote
You can use up to 16 remotes within 100 ft. of each other without
interfering with each other by setting each remote to a different Master
Code. To do this, press and release PC. Then press and hold Setup until the
indicator starts to blink. Release Setup (the indicator blinks a number
corresponding to its Master Code 1-16 and then stays on). While the
indicator is on, enter a new number for this remote (1-16) and then press
setup. The indicator blinks back the new setting and then stays off. Repeat
this process for each remote, setting a unique number (1-16) for each
remote.