User's Manual

ManualsBrandsAuthinx ManualsMusic PlayersRemote Music Player

SOFTWARE INSTALLATION FOR DELUXE SYSTEM (VT42A)

Before you install the software, unpack the hardware components and have

the Sender (Model VT42A) near your PC ready to connect it up when the

Lola software installation program instructs you to do so.

IMPORTANT: Do NOT connect the USB connector before you

install the software.

Log on to the Internet and go to the web address in the e-mail you received

when your order was confirmed (or visit www.x10.com/software). There

you will be able to install the software (you need to be connected to the

Internet while you install the software). Follow the instructions to install it.

At the appropriate point in the installation you will be instructed to plug the

Sender’s USB connector into your PC’s USB port. When you do this,

Windows® will tell you it has found new hardware and will automatically

install the X10 USB driver for the Sender. Follow the instructions to

complete the software installation.

USB connector

Do not connect to

your PC until you

install the Lola

software.

Model

VT42A

Windows® is a registered trademark of Microsoft Corporation.

After the software installation is complete, connect the VT42A’s power

supply to the jack on the back of the unit and plug the power supply into an

AC outlet. Make sure the switch on the side of the unit is ON.

Model CM19A

INSTALLING THE SOFTWARE

Basic vs Deluxe Systems

The Basic System includes the UR89A remote control, a CM19A USB

PC Receiver, the Lola software, and all connecting cables.

The Deluxe System includes the UR89A remote control, a VT42A

Wireless Audio/Video Sender with built in USB PC Receiver, a Wireless

Audio/Video Receiver, the Lola software, and all connecting cables.

Go to page 12 if you purchased the Deluxe System.

SOFTWARE INSTALLATION FOR BASIC SYSTEM (CM19A)