User's Manual

DECLARATION OF CONFORMITY (FCC)
This device complies with Part 18 of the FCC Rules.
CAUTION: Changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the product.
NOTE: This equipment has been tested and found to comply
with the limits for a wireless power charger, pursuant to Part
18 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
1) During the charging process, the transfer of electricity gives
off heat. Your device may become warm, but should not
become exceedingly hot.
2) If the device gets wet please cease charging immediately
Remove all plugs and dry the product completely Device is
only to be operated in a dry indoor environment.
3) Please be careful of excessive drops, dents, punctures , or
deformities on the device. If you are concerned, please
unplug the device and contact the manufacturer.
4) Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment .
5) Operating this device in a hot environment or in direct
sunlight for a long period of time may cause malfunctions. We
recommend keeping the product in cooler temperatures.
6) Please use included components for an optimal experience
To support Qi fast charge when using a third party car charger
or a USB Power Adapter use a minimum output of both "9.0V-
1.67A or 5.0V-2.0A".
7) The product's signal could possibly interfere with you
TPMS (tire pressure monitoring system) If you notice that your
TPMS light turns on, please try using your mount in different
locations to avoid the signals from interfering with each other.
OPERATIONAL WARNINGS ASSEMBLING MOUNT
Qi Wireless Fast
Charging
Charge up to 40% faster
than standard wireless
charging
Remove Cradle Knob from back
of Cradle and place over ball joint
into the Mount Base.
1
Tighten Cradle Knob.
2
Loosen the telescopic knob to
extend the arm,and tighten to
secure distance.
3
Loosen the side knob to pivot the
view angle and tighten to secure
position.
4
CHARGING INDICATOR
Your device's screen will show
that it is charging.
180°
Power-on : red lamp flickered,
blue lamp flickered, red and blue
lamps flickered simultaneously.
Standby: red and blue lamps are
lights out.
Full charge: red and blue lamps
lighting together (requires the
support from the receiving end).
Fault indication status:
FOD: red and blue lamps flicker alternately.
Input voltage / coil voltage overvoltage: red and blue lamps
flicker alternately.
Over temperature: red lamp flickers.
PS: indicator status can be customized according to
customer's requirements.
Suction cup base provides a strong secure hold on dash’s, windshield,
desks, tables and other surfaces.