Installation manual

ManualsBrandsAuto Page ManualsAutomobile AlarmRF-502

Power Cable from the

Master Operatorr Arm

RECEIVER

SWITCH

MASTER INPUTS

GRN WHT BLUE BRN ORG RED BLK COM COM

CYCLE

SAFETY

EXIT/

OPEN

SHADOW

LOOP

EDGE

OPEN

EDGE

BLKGRN RED

STALL FORCE

Step 4

Insert the stripped power cable wires into the appropriate

terminals on the

MASTER

operator terminal block. The

green wire should be inserted into the

GRN

terminal, the

blue wire into

BLU

, the orange wire into

ORG

, black

wire into

BLK

, and the red wire into the

RED

terminal.

Tighten the set screws against the end of the wires. A

dab of petroleum jelly on each terminal will help prevent

corrosion.

Correct

Wrong Wrong

Wire

Terminal 

Block

Terminal 

Block

Terminal 

Block

Wire Wire

Connecting Opener Power Cables

MASTER Operator

Step 6

Strip approximately

/16" of insulation from each wire

of the

40 foot

power cable

. Twist each exposed wire

tightly. Insert the second opener power cable upward

through the

right

strain relief

(if necessary, loosen the

strain relief (if necessary, loosen the strain relief

sealing nut). Thread approximately 4" of wire into the

control box. Retighten strain relief (on the

black sheath

of the power cable) until the power cable locks into

place.

Insert the stripped wires of the power cable into the

appropriate terminals on the

SLAVE

operator terminal

block. The green wire should be inserted into the

GRN

terminal, the blue wire into

BLU

, the orange wire into

ORG

, black wire into

BLK

, and the red wire into the

RED

terminal.

Tighten the set screws against the end of the wires.

Step 5

Review the

Installation Overview

illustration on

page 11

before proceeding.

Cut a slot into the driveway to accommodate PVC conduit (

not provided

). The buried conduit will protect the 40 foot power

cable from automobile tires, lawn mower blades, weed eaters, and grazing animals.

Pull the 40 foot second opener power

cable through the conduit and secure them into the slot in the driveway.

SLAVE Operator

SWITCH

RELAY OUT SLAVE INPUTS

GRN WHT BLUE BRN ORG RED BLKNC RLY-COM NO

MASTER INPUTS

GRN WHT BLUE BRN ORG RED BLK COM COM

Power Cable from the

Slave Operator Ar