RS-620 PROFESSIONAL REMOTE CAR STARTER & KEYLESS ENTRY SYSTEM OPERATIONS MANUAL THIS PRODUCT IS DESIGNED FOR PROFESIONAL INSTALLATION ONLY 1
SYSTEM OPERATIONS: WARNINGS: As with any product that performs automatic functions, there are certain safety precautions that you must practice and be aware of. 1. Keep the transmitter out of children’s reach. 2. Do not leave anyone in the vehicle while running on remote control. 3. Alert servicing personnel that the vehicle can be started automatically. 4. Do not start the vehicle by remote while it’s in an enclosed area or garage. 5.
XT-33: This transmitter uses two (2) 3-volt lithium ion batteries (#CR2016) that are sandwiched together with the (+) side facing upward. To replace the battery, you will need to use a small flat blade screwdriver. Locate the small notch on the lower right side of the transmitter case next to the key ring. Using the flat blade screwdriver, carefully pry the top case from the bottom case. It should snap apart after breaking the seal.
LED DISPLAY: LED Function Off Slow Flash On (Solid) Unlock Locked Valet Mode CHIRP INDICATOR: Chirp 1 chirp 2 chirps 6 chirps Function Lock Unlock Car Locator PARKING LIGHTS: Parking light 1 flash 2 flashes 12 flashes Constant On Function Lock Unlock Car Locator Under Remote Start DEACTIVATING WITHOUT A TRANSMITTER The Override function may be used if the remote transmitter is lost or inoperative. 1. Enter the vehicle and turn the ignition switch to ‘ON’ position. 2.
PANIC FUNCTION: (IF CAR HORN IS INSTALLED) The transmitter can be used as a remote panic switch to manually trigger the vehicle’s horn in case of emergency. 1. Press and hold the button for 3 second. The horn will immediately sound. 2. During panic mode, the normal function of this transmitter button will be suspended.
REMOTE START OPERATION: WARNINGS: As with any product that performs automatic functions, there are certain safety precautions that you must practice and be aware of. 1. Keep the transmitter out of children’s reach. 2. Do not leave anyone in the vehicle while running on remote control. 3. Alert servicing personnel that the vehicle can be started automatically. 4. Do not start the vehicle by remote while it’s in an enclosed area or garage. 5.
TO OVERRIDE VEHICLE FROM REMOTE START CONTROL: To operate the vehicle while running from the remote start. 1. Insert the ignition key and turn it to “ON” (not the start) position. 2. Press the brake pedal. Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down. TEMPORARY STOP FEATURE: This feature allows the vehicle to remain running after the key has been removed from the ignition.
SHUTDOWN INPUT FOR REMOTE STARTER: If any of the following conditions exist while the system is operating, the engine will not start or will shut down immediately: 1. The hood is opened. 2. The brake pedal is pressed. 3. Move the optional remote start enable toggle switch to OFF position. (If installed) 4. Engine is over-revved. {“Tachometer checking type” only} 5. The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed. 6. Transmitter button is pressed. 7.
LIMITED LIFETIME WARRANTY PROVISIONS ( U.S. ,Continental U.S. and Canada Only) 1. Auto Page, Inc. WARRANTS that this new unit has been thoroughly inspected and tested at the factory prior to delivery.
**IMPORTANT NOTE: Any damages to the alarm system resulting from an installation performed by anyone other than a professional installation technician authorized by a dealer of Auto Page will void the product’s limited lifetime warranty. This WARRANTY CARD is for your record. However, Auto Page reserves the right to request you to submit this WARRANTY CARD, which must have complete information to receive warranty service. Please keep this card in a secured place.
PAGE IS LEFT BLANK INTENTIONALLY 11
960 Knox Street Unit B, Torrance, CA 90502 Tel: (310) 323-1800 or (800) 262-2527 www.autopageusa.
