Hardware manual

DA-660/662 Hardware Hardware Introduction
2-5
LED Indicators
LED indicators are located on the front panel of the DA-660/662. Note that the DA-660 has two LAN ports, and
the DA-662 has four LAN ports.
LED Name LED Color LED Function
Ready Red Power is On, and system is ready (after booting up)
LAN1, LAN2,
LAN3, LAN4
Orange 10 Mbps Ethernet connection
Green 100 Mbps Ethernet connection
P1-P16 (Rx)
Orange Serial port is receiving RX data from the serial device
Off Serial port is not receiving RX data from the serial device
P1-P16 (Tx)
Green Serial port is transmitting TX data to the serial device
Off Serial port is transmitting TX data to the serial device
Reset Button
Press the Reset button on the front panel continuously for at least 5 seconds to load the factory default
configuration. After the factory default configuration has been loaded, the system will reboot automatically.
The Ready LED will blink on and off for the first 5 seconds, and then maintain a steady glow once the system
has rebooted.
We recommend that you only use this function if the software is not working properly and you want to load
factory default settings. To reset an embedded Linux system, always use the software reboot command
/>reboot to protect the integrity of data being transmitted or processed. The Reset button is not designed to
hard reboot the DA-660/662.
ATTENTION
Pressing the Reset button will only load the configuration file. All files in the /etc directory will revert to their
factory defaults, and all user data in the Flash ROM will be deleted.
LCD Screen
The DA-660/662 has an LCD screen on the front panel. The LCD screen can display 16 columns and 2 rows of
text. After the DA-660/662 boots up, the LCD screen will display the model name and firmware version:
D A - 6 6 2 - 1 6
V E R . 1 . 0