Specifications

TAKE YOURS ON AN ADVENTURE

Truma S3002 Vehicle Space Heater

Vehicle Space Heater -

Truma S3002

The S3002 heater incorporates a 3kw gas

burner and a 2kw mains electric element

(known as Ultraheat).

If the two energy sources are used

simultaneously this gives a maximum heat

output of 5kw. The heater also incorporates

a 12V blown air heat distribution system that will

deliver warm air through blown air ducts running

throughout the vehicle.

Igniting The Heater

Before operating the heater for the first time

ensure that the batteries are fitted to the ignition

unit, and that the gas cylinder, and isolation

valve are turned on.

• Turn on the control knob to the desired

thermostat setting (from 1 to 10) and

press down as far as the stop.

• Ignition will take place automatically until the

flame ignites. Keep the control knob pressed

down for a further ten seconds to allow the

safety pilot to operate.

• If the flame should go out then automatic

ignition will occur immediately during the

closing time of the safety pilot (approximately

30 seconds). If there is no flame present the

igniter will continue to operate until the

control knob is switched to ‘0’.

2090 AT Apache-Tracker Owners Handbook REPRO 2:Layout 1 18/11/08 14:36 Page 27