Installation Manual

2” (5 cm)

hood shield

weatherstrip

hood

phillips screw

washer

Remove and discard (4) fasteners from hood

weatherstrip noted in Step 2.

Carefully slide (4) inboard hood shield flanges under

weatherstrip and align hood shield with holes in hood.

Install (4) phillips screws with washers as indicated.

Clean outboard edges of hood with an

alcohol pad.

Peel back 2” (5cm) of tape liner from each

end of hood shield.

NOTE: Actual application may vary slightly from drawings.

Installation Steps

Do not overtighten

Remove tape liner from both outboard flanges.

Page 2 of 3

3 4