Installation Manual

NOTE: Actual application may vary slightly from drawings.
Installation Steps
Page 2 of 3
1 2
3
4
7
8
Choose the appropriate installation method for your vehicle by
viewing mirror diagram.
or
Remove the interior plastic mirror cap by pulling outwards.
NOTE: Deflectors mount on the OUTSIDE rubber trim of
door frame.
Remove the (2) rubber caps to expose mirror mounting hardware.
Temporarily remove the strip of adhesive tape.
Scuff the rubber trim where the visor will mount with a
scotch brite pad and clean with an alcohol pad. Then
apply one coat of surface prep and let air dry.
Remove tape liner from front flange. Peel back 2” (5 cm) of tape
liner from each end of top flange.
free end
top flange
rear
flange
front
flange
free end
Loosen but do not totally remove the (4) exposed
nuts to expose a gap necessary for the front end
flange installation. Proceed to Step 7
5
6
4
Loosen but do not totally remove the (5) exposed nuts
to expose a gap necessary for the front end flange
installation. Proceed to Step 7
NOTE : 2008 and newer models proceed to Step 3.
2007 and older models proceed to Step 5.
Remove the (2) rubber caps to expose mirror mounting hardware.
Temporarily remove the strip of adhesive tape.