Installation Manual

3
Front Air Dam
1
Page 2 of 3
Installation Steps
4
Clean the door’s trim & mirror cap
visor will attach.
2
free end
Remove the tape liner from the front & rear flanges.
Peel back 2” of tape liner from each end of top flange.
Attach the front flange to the mirror cap. Attach the top
and rear flanges to the door’s window trim. Remove
tape liner by pulling on free ends.
Apply pressure to the tape flanges to secure.
top flange
rear
flange
front
flange
4 Piece Set
The rear visor attaches with same preparation methods as the front visor.
Attach visor to the vehicle’s window trim.
5
rear visor
attached to
trim
vertical
window
post
NOTE: Actual application may vary slightly from drawings.