Installation Manual

3
1
Page 2 of 3
Installation Steps
4
Clean the door’s painted surface & mirror
cap where the visor will attach.
2
free end
Remove the tape liner from the front & rear flanges.
Peel back 2” of tape liner from each end of top flange.
Attach front flange to mirror cap Attach the top and rear
flanges to the door’s painted surface. Remove tape liner
by pulling on free ends.
Apply pressure to top and rear tape flanges to secure.
top flange
rear
flange
front
flange
4 Piece Set
The rear visor attaches with same preparation methods as the front visor.
Attach visor to the vehicle’s painted surface.
5
OR
NOTE: Actual application may vary slightly from illustrations.