Instruction manual

ManualsBrandsautocom ManualsAutomotiveKit SP-A

INSTRUCTION

MANUAL

It is very important that you fully read and understand all of

these instructions before installation and use.

These parts are designed for domestic motorcycle use.

2009 Bluetooth Modules

Logic Systems Internal Modules

2217

2218

2221

2223

2224

Single stereo Bluetooth internal module, for use with Kits L-1 and L-IW

Twin stereo Bluetooth internal module, for use with Kit L-1

Optional remote cable and housing, for use with Part 2217 or 2218 when a Logic is

bike powered.

Single stereo Bluetooth remote module, for use with Kits SP-A and SP-ARC

Twin stereo Bluetooth remote module, for use with Kits SP-A and SP-ARC

Super Pro Systems Remote Modules

Bluetooth Modules Manual v4 29/6/09 10:54 am Page 1

Summary of content (8 pages)

PAGE 1
Bluetooth Modules Manual v4 29/6/09 10:54 am Page 1 INSTRUCTION MANUAL 2009 Bluetooth Modules Logic Systems Internal Modules 2217 Single stereo Bluetooth internal module, for use with Kits L-1 and L-IW 2218 Twin stereo Bluetooth internal module, for use with Kit L-1 2221 Optional remote cable and housing, for use with Part 2217 or 2218 when a Logic is bike powered.
PAGE 2
Bluetooth Modules Manual v4 29/6/09 10:55 am Page 2 Internal Modules for Logic Systems STEREO BLUETOOTH INTERNAL MODULES PARTS 2217 AND 2218 Fitting the Bluetooth Module A Unplug the headsets from the control unit, remove the battery cover and the batteries or bike power lead. (Picture A). Turn the control hub over and lay it on a clean dry cloth with the label side up, peel the label off and remove the two screws. (Picture B).
PAGE 3
Bluetooth Modules Manual v4 29/6/09 10:55 am Setting the MODE selector switch Page 3 F Set the mode selector switch to Mode 2 (pictures F and G) to make the audio affect other inputs as Aux 2 does. Set the mode selector switch to Mode 3 (pictures F and H)to make the audio affect other inputs as Aux 3 does, this is the standard factory setting.
PAGE 4
Bluetooth Modules Manual v4 29/6/09 10:55 am Page 4 Remote Extension for Logic Systems USING PART 2221 - REMOTE LEAD HOUSING Recommended to be used when you bike power a Logic system. Position Part 2217 or 2218 into the remote housing as shown in picture K. Set the mode selector switch to mode 2 or 3 (as shown on page 3, pictures F, G and H). Connect end A of the remote lead to the main PCB in the housing (picture L).
PAGE 5
Bluetooth Modules Manual v4 29/6/09 10:55 am Page 5 Remote Modules for Super Pro Systems STEREO BLUETOOTH REMOTE MODULES PARTS 2223 AND 2224 Fitting the Bluetooth Module With the single module the 3.5mm jack plug is inserted in one of the 3.5mm Aux sockets found on the front panel of the Super Pro system (picture 1). With the twin module the 3.5mm jack plugs are inserted in two of the 3.5mm Aux sockets found on the front panel of the Super Pro system (picture 1).
PAGE 6
Bluetooth Modules Manual v4 29/6/09 10:55 am Page 6 CONNECTIVITY • LOGICAL MIXING AND CONTROL Aux 2 • designed for Stereo GPS Incoming audio on Aux 2 automatically reduces the stereo music level on Aux 4 to 50% to improve speech clarity, while automatic gain control compensates for varying noise/speeds and the stereo audio can be faded between the rider and passenger headsets (auto reduction and/or auto gain control can be switched off for improved earplug use).
PAGE 7
Bluetooth Modules Manual v4 29/6/09 10:55 am Page 7 GENERAL INSTALLATION OF REMOTE MODULES Plan where you intend to route your lead between your module and Autocom system on the bike, ensuring that the lead will reach between them. Avoid placing any parts near areas of high heat (engine, exhaust etc), or near electrical noise (HT leads and coils, alternator and regulator etc) and where they may be exposed to extreme damp (near to wheels or exposed areas under the fairing etc).
PAGE 8
Bluetooth Modules Manual v4 29/6/09 10:55 am Page 8 MANUFACTURERS 12 MONTH WARRANTY If your supplier has not given advice or demonstrated how to set up or use our products, please check with them before sending any goods back for warranty. All Autocom products are under warranty for a period of 12 months from the date of original purchase, to the original purchaser, from an authorised Autocom retailer.