Specifications

Integrating Voice Mail with Cisco SRST
How to Integrate Voice Mail with Cisco SRST
137
Cisco IOS Survivable Remote Site Telephony Version 3.4 System Administrator Guide
How to Integrate Voice Mail with Cisco SRST
This section contains the following tasks:
• Configuring Direct Access to Voice Mail, page 137 (Required)
• Configuring Message Buttons, page 140 (Required)
• Redirecting to Cisco CallManager Gateway, page 142 (Required for BRI or PRI))
• Configuring Call Forwarding to Voice Mail, page 142 (Required FXO or FXS)
• Configuring Message Waiting Indication, page 147 (Optional)
Configuring Direct Access to Voice Mail
To access voice-mail messages with FXO or FXS access, you must have POTS dial peers configured
with a destination pattern that matches the voice-mail system’s number. Also, you must associate the
dial peer with the port to which the voice-mail system is accessed.
Both sets of configurations are done in global configuration mode and in dial-peer configuration mode.
The summary and detailed steps below include only the basic commands necessary to perform this task.
You may require additional commands for your particular dial-peer configuration.
For additional information about the commands in the steps below, see the Cisco IOS Voice, Video, and
Fax Command Reference, Release 12.2T.
SUMMARY STEPS
1. dial-peer voice tag {pots | voatm | vofr | voip}
2. destination-pattern [+] string [T]
3. port {slot-number/subunit-number/port | slot/port:ds0-group-no}
4. forward-digits {num-digit | all | extra}
5. exit