iPad LiteGuide

5. Centre the lens in the

aperture at the rear of

the hood, by raising or

lowering the hood.

Secure it in place by

tightening the two thumb

screws. (B)

iPad Lite

Guide

Mounting the Camera

It is important that the camera lens is in the centre of

the aperture at the rear of the hood. This is achieved by

raising and lowering the hood and fitting a camera

riser.

Fix the camera in place

using the camera screw

provided.

1/4” BSW

Camera Screw

Camera Riser

2. Install camera riser to

the camera mounting

plate using the camera

screw provided

3. Raise the camera to

the vertical position.

Secure by tightening

the four thumb screws.

4. Slide the camera

forward so that the lens

is in the aperture at the

rear of the hood.

1. Fit camera riser to

the camera.

autocue.com

(B)

PAGE 1
Mounting the Camera 2. Install camera riser to the camera mounting plate using the camera screw provided 3. Raise the camera to the vertical position. Secure by tightening the four thumb screws. It is important that the camera lens is in the centre of the aperture at the rear of the hood. This is achieved by raising and lowering the hood and fitting a camera riser. 1/4” BSW 4. Slide the camera forward so that the lens is in the aperture at the rear of the hood.
PAGE 2
Components A D B C A Hood and Glass B iPad C Mounting Plate D Hood Adjustment Screws 2. Mount the unit on the tripod. 6. Raise the hood up into the vertical position. 3. To mount the iPad loosen the thumb screws (B) and slide the carrier to the open position. (B) Vertical position Assembly 1. Fix the hot shoe from your tripod to the underside of the mounting plate. Slide the hot shoe to the approximate position and tighten the screws. 4.