Manual

Guide

Digital Cue

Light Kit

Note: If there is not a camera tally light available, the tally

output socket that is fitted to most cameras can be used.

Remove the sensor head and fit compatible plug. (The two

conductors in the sensor cable need to be shorted to make

the cue light operate)

Cue Light Controls

Note: This step is not

required if the unit is

connected to the Tally

out socket.

autocue.com

Socket Pin out Note

Power Input Pin 1- / Pin 6+ 12v DC / 0.02mA

Sensor Input Pin 1 and 2 Short for operaon.

Sensor Mounting

8. Attach the self-adhesive

Velcro disc to the on camera

tally and secure the sensor to

the disc.

9. Plug in the power cable into the sensor socket. This will

provide power to the cue Light. This socket is only available

on the MSP range of monitors.

For use with the PSP range of monitors an additional 12V

DC power supply will be required.

11. Rotate this control until the desired camera

number is displayed.

10. The Trim Control adjusts the sensitivity of the sensor.

To set the level ensure that the on camera tally light is on

and the sensor is in place. Rotate the control clockwise

until the display changes from green to red. The sensor is

now set.

Connector Specifications

PAGE 1
Sensor Mounting Cue Light Controls 8. Attach the self-adhesive Velcro disc to the on camera tally and secure the sensor to the disc. Note: This step is not required if the unit is connected to the Tally out socket. Digital Cue Light Kit Guide 10. The Trim Control adjusts the sensitivity of the sensor. To set the level ensure that the on camera tally light is on and the sensor is in place. Rotate the control clockwise until the display changes from green to red. The sensor is now set.
PAGE 2
Components (A) (D) (B) (C) A Sensor Unit B Power Cord C Velcro Disc D Cue Light 2. Secure the Cue Light to the hood frame retainer using the small thumb screw provided. 5. In operation the Cue Light display changes colour from green to red when the sensor unit sees the camera tally light change. Assembly 3. Replace the catch plate and knob. (A) 6. To install the sensor, plug the unit into the socket marked sensor. (B) 1. Remove the knob (A) and catch plate (B) from the hood frame Retainer.