Wireless IR-Controller User Guide
Table of Contents Connecting Controller 1 Remote Settings 2 Start/Stop & Pause 2 Increase/Decrease Speed 2 Break Markers 3 Functions of Controller 3 Connecting Controller Take the IR-Controller cable jack and insert it into the headphone socket of the iPod Touch, iPhone or iPad as shown below. Please Note: When connecting the receiver to the device please ensure you push it hard until it clicks to ensure it works correctly.
Remote Settings Before you are able to use the IR–Controller you must set the correct ‘Remote Type’ within the software. To adjust the settings for the remote control tap the ‘Settings’ button at the bottom of the ‘Documents’ and scroll down to ‘Remote Settings’, you will then see an option labelled ‘Remote Type’ set this to ‘Wireless V2’. Below the table shows the recommended “fast” and “slow” times depending on the font size of the script.
Break Markers A ‘Break Marker’ is a character embedded into your script that you can use to jump to certain points within the script using the IR-Controller. The default “Break Marker” is “*#” but it can be a string of up to 10 characters. The “Break Marker” is case sensitive. To jump between break markers pause the script using the remote, then use the two 'speed' buttons to scroll forward and backwards through the break markers.
