User Guide

Guide
Straight-read Assembly
SSP07
Prompter
1. Place your SSP07 on a smooth, level
surface. Remove the thumbscrews holding
the hood and monitor mounng plate.
2. Remove the two thumbscrews
attaching the monitor mounting
bracket to the drop bracket.
3. Remove the thumbscrews
securing the monitor to the
monitor mounting bracket.
4. Align the bolt on the back of
the monitor mounting plate with
the hole in the centre of the drop
bracket.
5. Secure it to the drop plate
with the knob.
6. Attach an optional pistol
grip to the hot shoe plate on
the underside of the SSP07
unit.
7. Now attach your camera
to the camera mounting
bracket using the screw
supplied.
Camera screw
Mount the camera to the camera mounting bracket
using the 1/4” BSW camera screw, slide the camera
forward and ensure that the lens is inside the hood.
Use the hood slide screw to centre the lens inside
the hood and place the black light excluder around
the lens. Secure it using the drawstring.
Mounting the Camera
Camera Balancing
Loosen the two screws
(marked A in the picture) so
that the hot shoe plate will
slide back and forth.
A
A
Mount the unit with
camera attached to the
tripod and slide the unit
back and forth until you
achieve a balance.
Then retighten the
screws.
autocue.com