User Guide User guide

SSP17/10

Guide

Camera Fixing

Fix the camera in place

using the camera

screws provided.

1/4” BSW

3/8” BSW

Connect the power supply

and the VGA or video cable.

10” Monitor

17” Monitor

Alternative Configurations

The SSP 17” and 10” can be reconfigured into

different prompting solutions.

Straight Read Configuration

1. Remove the hood and monitor.

2. Mount the monitor to the monitor

mounting plate. (A)

3. Mount the monitor to the hood up-

rights. (B)

Free Standing Configuration

1. Remove the hood upright mount-

ing.

2. Mount the monitor on the monitor

mounting plate.

3. Attach to any tripod with a 1/4”

BSW fixing.

Floor Standing Configuration

1. Remove the hood assembly.

2. Remove the monitor

assembly and mount on the

opposite side of the plate.

autocue.com

PAGE 1
Alternative Configurations Camera Fixing SSP17/10 The SSP 17” and 10” can be reconfigured into different prompting solutions. B Straight Read Configuration 1. Remove the hood and monitor. A 2. Mount the monitor to the monitor mounting plate. (A) Fix the camera in place using the camera screws provided. 3/8” BSW 1/4” BSW Connect the power supply and the VGA or video cable. 3. Mount the monitor to the hood uprights. (B) Free Standing Configuration 1. Remove the hood upright mounting. 2.
PAGE 2
Components A A Hood and Glass B Monitor C Mounting Plate D B C D 2. 3. Lock the hood into position by tightening the four thumb screws. For larger cameras the mounting plate may need extending. Loosen the four thumb screws on the camera plate and remove the rear two, the plate will now slide out. Replace the two rear screws and tighten them to secure the plate. Hood Adjustment 3. For smaller cameras the camera plate will need to be raised.