User Manual

SSP17

Guide

Camera Fixing

16. Fix the camera in

place using the camera

screws provided.

1/4” BSW

17. Connect the power

supply and the VGA or

video cable.

Power Supply

autocue.com

12. For smaller cameras the camera plate will need

to be raised. Remove the four thumb screws and then

lift off the plate.

13. Install four camera plate pillars

of the appropriate height.

14 Re-fix the camera

plate using the four

screws provided.

15. To achieve the maximum

height, combine the long and

short pillars.

Pillar combinations

3/8” BSW

11. For larger cameras the mounting plate may need

extending. Loosen the four thumb screws on the

camera plate and remove the rear two, the plate will

now slide out. Replace the two rear screws and

tighten them to secure the plate.

PAGE 1
1. For larger cameras the mounting plate may need extending. Loosen the four thumb screws on the camera plate and remove the rear two, the plate will now slide out. Replace the two rear screws and tighten them to secure the plate. Camera Fixing SSP17 Guide 12. For smaller cameras the camera plate will need to be raised. Remove the four thumb screws and then lift off the plate. 13. Install four camera plate pillars of the appropriate height. 16. Fix the camera in place using the camera screws provided.
PAGE 2
Glass Installation Components A D B C A Hood and Glass B Monitor C Mounting Plate D 3. Remove the three thumb screws that secure the hood frame and open the hood. Hood Adjustment 9. The Hood is now locked in the upright position. 4. Place the glass in the hood and ensure that the glass is located in the recess. Assembly 5. The glass is installed with the blue dot facing up. A double image will be seen in the reflection if the glass is not installed correctly. 1.