Manual

WINCUEPRONEWS USER GUIDE
VERSION 1.30B515 63  QTV 1998
CLEAR No assigned function for the BASYS Interface.
DECODER
3.3.10
STOP Stop/Re-start the prompt scrolling.
Using the Foot Control to prompt
The scroll speed is controlled by increasing and decreasing the pressure applied to the foot
pedal (much like a car accelerator pedal). The red button on the foot control changes the
scroll direction in the same way as the Multibutton controllers FWD REV button.
If the Foot Control is attached to the back of a Multibutton Hand Control then the Foot Control
can be used in combination with the Multibutton Controls buttons.
3.3.11 Using WinCue to select the next story to prompt:
If it is necessary to jump the prompt to a story that is not the next or previous story in the
runorder then you can use any of the following three methods.
1: Hold down the left 'Alt' key and double left-click on the story you want to start
prompting.
2: Right-click on the story you want to start prompting, then select 'P
rompt From
Here' from the drop-down menu that appears.
3: Left-click on the story you want to start prompting, this will select the story (shown
by the black bar), then hold down the left 'Alt' key and press the 'Return' or 'Enter' key.
After using any one of these methods, the prompt and the WinCue prompt (yellow) bar will
move/jump to the chosen story.
3.3.12 Changing the Font and Font Size for prompting on WinCue
Changing the Font and Font Size only for the current runorder:
To change the font or font size for just the current runorder you must do the following:
NOTE: If you want the new Font and Font Size to affect the current runorder and the
default for all BASYS Runorders you should place a tick (by left clicking on the box) in