9

250 Chapter 5: Creating Geometry
Leaf Parameters rollout
Provides controls that affect the door itself (as
opposed to the door unit, which includes the
fr ame). You can adjust the dimensions of the
door, add panels, and adjust the dimensions and
placement of those panels. The total number of
panelsforeachdoorelementisthenumberof
horizontal divisions times the number of ver tical
divisions. Pivot doors have a single door element
unlesstheyaredoubledoors.BiFolddoorshave
two door elements, or four if they are double
doors. Sliding doors have two door elements.
Thick ness—Sets the thickness of the door.
Stiles/Top R ail—Sets the width of the panel framing
on the top and sides. This setting is apparent only
if the door is paneled.
Bottom Ra il—Sets the width of the panel framing at
thebaseofthedoor.Thissettingisapparentonly
if the door is paneled.
#PanelsHoriz.—Sets the number of panel divis ions
along the horizontal axis.
# Panel s Vert .—Sets the number of panel divisions
along t he vertica l axis.
Muntin—Sets the width of the separations between
the panels.
Panels group
Determines how panels are created in the door.
None—The door has no paneling.
Glass—Creates glass panels with no beveling.
Thickness—Sets the thickness of the glass panels.
Beveled—Choose this to have beveled panels.
The remaining spinners affect the beveling of the
panels.
Bevel Angle—Specifies the angle of the bevel
between the outer sur face of the door and the
surface of the panel.
Thickness 1—Sets the outer thickness of the panel.
Thickness 2—Sets the thickness where the bevel
begins.
Middle Thick.—Sets the thickness of the inner part
of the panel.
Width 1—Sets the width where the bevel begins.
Width 2—Sets the width of the inner p ar t of the
panel.