9

Garment Maker Modifier 619
Density —Controls the mesh density of a selected
panel. This value is applied as a multiplier of the
Main Parameters rollout > Density setting.Youcan
increase the density of a particular panel by raising
this value.
If Main Parameters rollout > Auto Mesh is off
when you change this value, go back to the Main
Parameters rollout (Cloth level in modifier stack)
and click Mesh It! to update the mesh. For this
reason, it is recommended that you leave Auto
Mesh on. The only time you might want to turn
off Auto Mesh is while creating the seams at the
Curves sub-object level. Re-meshing can take
some time, so you might want to define a number
of seams before re-meshing.
Different Density settings applied to sepa rate panels
Mat ID—Set the material ID for the selected panel.
Usingthisoptionenablesyoutoassigndifferent
materials to select portions of the clothing.
Position group
Reset—Resets the position of the selec ted panels
to their original locations (that is, the locations
immediately after Garment Maker was applied).
Reset All—Resets the posit ion of all panels to their
original locations.