9

832 Chapter 8: Modifiers
4.
In the viewpor ts, select vertices, segments, or
splines.
Tip: You c an transform the selection using an
XForm modifier (page 1–959) or Linked XForm
modifier (page 1–712).
Inter face
Modifier Stack
The sub-object level you choose for the spline
select modifier determines which rollout appears.
(There are no parameters at the top, object level.)
Vertex—Creates a sub-object selection of vertices.
Segment—Creates a sub-object selection of
segments.
Spline—Creates a sub-object selection of splines.
For more information on the stack display, see
Modifier Stack (page 3–760).
Selec t Vertex rollout
Get Segment Selection, Get S pline Selection—Select
vertices based on the last Segment or Spline
selection. This selection is added to the c urrent
selection. Available only when Vertex is not the
current sub-object level.
Select Se gm ent rollout
Get V er tex S election, Get Spli ne S election—Select
segments based on the last vertex or spline
selection. The selection is added to the current
selection. Available only w hen Segment is not the
currentsub-objectlevel.
Select Spline rollout
Get Vertex S el ection, G et S egment Sel ection—Select
splines based on the last vertex or segment
selection. The selection is added to the current
selection. Avai lable only w hen Spline is not the
currentsub-objectlevel.
Copy/Paste Selection controls (all rollouts)
Co py—Places a named selection into the copy
buffer.
Pas t e—Pastes a named selection from t he copy
buffer.