9

Sweep Modifier 853
Thick ness—
Controls the thickness of b oth legs of
the channel. Default=0.5.
Sync Corner Fillets—When on, Corner Radius 1
controls the radius of both the interior and exterior
corners between the vertical web and horizontal
legs. It also maintains the thickness of the section.
Default=off.
Co rner Radius 1—Controls the exterior r adius
between the vertical web and hor izontal legs of the
channel. Default=0.0.
Co rner Radius 2—Controls the interior radius
between the vertical web and hor izontal legs of the
channel. Default=0.5.
Note: Be cautious when adjusting these settings.
There are no constraining relationships between
them. Therefore, it’s possible to set an inside
radius(CornerRadius2)thatisgreaterthanthe
length of the web or width of the legs.
Parameters rollout – Cylinder
Radius—Controls the radius of the cylinder
sect ion. Default=3.0.
Parameters rollout – Half-Round
Radius—Controls the radius of the half round
sect ion. Default=3.0.
Parameters rollout – Pipe
Radius—Controls the exterior radius of the pipe
section. Default=3.0.
Thickness—Controlsthethicknessofthewallof
the pipe. Default=0.5.
Parameters rollou t – Quarte r-Round
Radius—Controls the radius of the quarter round
section. Default=3.0.
Parameters rollout – Te e
Lengt h—Cont rols the height of the vertical web of
the tee section. Default=12.0.
Width—Controls the width of the flange crossing
the tee section. Default=6.0.
Thickness—Controlsthethicknessoftheweband
flange. Default=0.5.
Co rner Radius—Controls the radius of the two
interior corners between the vertical web and
horizontal flange of the section. Default=0.5.
Note: Be cautious w hen adjusting t hese settings.
There are no constraining relationships between
them. Therefore, it’s possible to set a radius
(Corner Radius) that is greater than the length of
the web or width of the flange.