9

Sweep Modifier 855
Sweep Parameters rollout
Mirror On XZ Plane—When turned on, the sect ion
is flipped vertically in relation to the spline to
which the Sweep modifier is applied. Default=off.
Left: The object shows the default state.
Right: The object has Mirror On XZ Plane turned on.
Mirror On XY Plane—When turned on, the section
is flipped horizontally in relation to the spline to
which the Sweep modifier is applied. Default=off.
Left: The object show s the defa ul t sta te.
Right: The object has M i rror On XY Plane turned on.
XOffset—Lets you shift the horizontal p osition of
the section relative to the underlying spline.
Left: The section is in the default position.
Right: The section is offset –10 relative to the u nderlying spline
path (red).
YOffset—Lets you shift the vertical position of the
section relative to the underlying spline.
Left: The section is in the default position.
Right: The section is offset –10 relative to the u nderlying spline
path (red).
Note: The X and Y Offsets let you fine tune the
section position while the Pivot Alignment settings
allow for a quick initial adjustment.