2011

You can set up your type “0” pin list assignment to handle different pin
assignments depending on the physical orientation of the contact in the relay
body by encoding the symbol PINLIST of the relay coil like:
0,1A,1B,1C,1D;0,2A,2B,2C,2D;0,3A,3B,3C,3D;0,4A,4B,4C,4D
Each type “0” contact (convertible contact flag) is followed by four pin
assignments instead of the normal two. The first two assignments default to
the contact when it is inserted as a N.O. contact. If the contact is flipped to
N.C., the last two assignments are applied.
Modify the PINLIST data for four convertible contacts
1 Insert a relay coil.
2 On the Insert/Edit Component dialog box, Cross-reference section, click
NO/NC Setup.
3 Enter the PINLIST data (shown previously) in the Pin List field on the
Maximum NO/NC counts and/or allowed Pin numbers dialog box.
4 Insert a N.O. contact and associate it to the parent coil.
The pin assignments are “1A” and “1B.”
5 Click Schematic tab ➤ Edit Components panel ➤ Toggle NO/NC.
6 Select the N.O. contact to flip it to a N.C. contact.
The pin assignments automatically update to “1C” and “1D.”
Set pin list assignments for special uses | 1313