2011

Insert wiring
1 If AEGS is not the active project, in the Project Manager, right-click AEGS
and select Activate.
2 In the Project Manager, double-click AEGS to expand the drawing list.
3 In the Project Manager, Project Drawing List, double-click AEGS04.dwg.
4 Zoom in on the upper left corner of the drawing. Make sure the hot and
neutral vertical wires are displayed.
5 Click Schematic tab ➤ Edit Wires/Wire Numbers panel ➤ Modify Ladder
drop-down ➤ Add Rung.
6 Respond to the prompts as follows:
Add rung passing through this location or [wiretype (T)]:
Select a location between the two vertical bus wires beside line reference 403
(1)
Add rung passing through this location or [wiretype (T)]:
Select a location between the two vertical bus wires beside line reference 404,
underneath the newly created rung (2), press ENTER
Two horizontal wires are created automatically between the vertical bus
wires at the closest line reference location.
Create two vertical wires between two horizontal wires
1 Click Schematic tab ➤ Insert Wires/Wire Numbers panel ➤ Insert Wires
drop-down ➤ Wire.
2 Respond to the prompts as follows:
1740 | Chapter 23 Tutorials