2009

Note:
Holding down the CTRL key when moving a control bar prevents it from auto docking.
Using the Docking Tool
When you drag a control bar or a window pane from its current location towards a new destination on the
interface, a docking tool appears.
The docking stickers point towards the four edges of the interface.
When the control bar you are dragging is close to the place where you want it to dock, move the mouse
over the corresponding area of the docking tool. You will see an outline of the control bar appear on the
interface. To dock the control bar there, release the mouse button.
Tiling Control Bars
You can tile control bars and window panes on the interface. To do this, drag a control bar you want to tile
over the control bar where you want it to be placed. When a rectangular outline appears, release the
mouse button.
Auto Hiding Control Bars
You can auto hide control bars and window panes; this keeps the control bars active while maximizing
the amount of available screen space. If auto-hide is active, the body of the control bar disappears when
you move the cursor out of it, leaving only the title bar visible. Move the cursor over the title bar to display
the entire control bar again.
To switch auto-hide on, click on the title bar. To switch auto-hide off, click on the title bar.
The Status Bar
The Status bar appears at the bottom of the NavisWorks screen.
The left-hand corner of the Status bar is used to display short instructions on how to use the NavisWorks
features.
Interface
86