2010

Table Of Contents

When this check box is clear, the Walk tool disregards the world up vector, and the camera is walked with its

current up orientation unaffected.

Walk Speed Sets the speed of the Walk tool from 0.1 (very slow) to 10 (very fast).

Zoom Tool

Enable Single-Click Incremental Zoom In When this check box is selected, single clicking over the Zoom

wedge increases the magnification of the model. When this check box is clear, nothing happens when you single

click over the Zoom wedge.

Orbit Tool

Keep Scene Upright When this check box is selected, the Orbit tool behaves similarly to orbit navigation mode,

with orbiting constrained along the XY axis and in the Z direction.

When this check box is clear, the Orbit tool behaves similarly to examine navigation mode, and you can roll

the model around the pivot point.

Enable Selection Sensitivity When this check box is selected, the objects selected before the Orbit tool are used

to calculate the pivot point to use for orbiting. The pivot point is calculated based on the center of the extents

of the selected objects.

File Readers Node

DWF Page

Use this page to adjust the options for the DWF file reader.

Faceting Factor Enter the required value to control the level of faceting that takes place.

The faceting factor must be greater or equal to 0, where 0 results in the faceting factor being turned off. The

default value is 1. To get twice the number of facets, double the value. To get half as many facets, halve the value.

Larger faceting factors result in more polygons to a model and larger Autodesk Navisworks files.

Max Facet Deviation This setting controls the greatest distance between the edge of a facet and the actual

geometry.

If this distance is greater than the Max Facet Deviation value, Autodesk Navisworks adds more facets.

If the Max Facet Deviation is set to 0, then this function is ignored.

Extract Textures Select this check box to extract textures and environment maps associated with the file.

NOTE Environment maps are not set in the scene by default, and must be configured in Presenter manually.

When this check box is clear, the file reader ignores maps and textures.