2010
Table Of Contents
- Contents
- Welcome to Autodesk Navisworks Freedom 2010
- Installation
- Quick Start to Stand-Alone Installation
- Prepare for Installation
- Install and Run Autodesk Navisworks Freedom 2010
- Installation Troubleshooting
- General Installation Issues
- Uninstall and Maintenance Issues
- When adding or removing features, how can I tell what features get installed by default?
- Is it possible to change the installation folder when adding or removing features?
- When should I reinstall the product instead of a repair?
- Do I need my original disk to reinstall my software?
- When I uninstall my software, what files are left on my system?
- Quick Start to Stand-Alone Installation
- Quick Start
- Get a Whole-Project View
- Work with Files
- Explore Your Model
- Control Model Appearance and Render Quality
- Review Your Model
- Use Viewpoints and Sectioning Modes
- Play Back Animations
- Work Within a Team
- Share Data
- TimeLiner Playback
- Autodesk Navisworks Reference
- Glossary
- Index
3 Do one of the following:
■ Press and hold down the SHIFT key to enable the Up/Down tool; drag up or down.
■ Press and hold down the UP ARROW or DOWN ARROW key.
4 Release the button on your pointing device to return to the wheel.
Zoom Tool
You use the Zoom tool to change the zoom magnification of a model.
NOTE When you start the Zoom tool from the Full Navigation wheel, incremental zooming must be enabled in the
Options Editor in order to use CTRL+click and SHIFT+click.
Zoom Constraints
When changing the magnification of a model with the Zoom tool, you cannot zoom in any further than the
focus point or out past the extents of the model. The direction you can zoom in and out is controlled by the
center point set by the Center tool.
NOTE Unlike the Zoom tool on the big View Object wheel, the Zoom tool on the mini View Object wheel and the
Full Navigation wheels are not constrained.
To zoom the view with a single click
NOTE You must enable incremental zoom when using the Full Navigation wheels, or a mini View Object wheel. For
the big View Object wheel, the incremental zoom is always enabled.
1 Do the following to make sure the Enable Single-Click Incremental Zoom In option is selected:
a Display the Full Navigation Wheel.
b Right-click the wheel, and click SteeringWheel Options.
c In the Options Editor, the SteeringWheels page under the Interface node, select the Enable Single-Click
Incremental Zoom In check box.
d Click OK.
2 Display a wheel that has the Zoom tool.
3 Click the Zoom wedge.
The magnification of the model is increased and you are zoomed in closer to the model. If you hold down
the SHIFT key while clicking the Zoom wedge, the model is zoomed out; you can hold down the CTRL key
to zoom in.
To zoom a view in and out by dragging
1 Display one of the Full Navigation wheels, or one of the View Object wheels.
2 Click and hold down the Zoom wedge.
The cursor changes to the Zoom cursor.
72 | Chapter 6 Explore Your Model