2012
Table Of Contents
- Contents
- Welcome to Autodesk Navisworks Freedom 2012
- What Is New in This Release?
- How to Get Assistance
- Installation
- Quick Start to Stand-Alone Installation
- Installation Troubleshooting
- General Installation Issues
- How can I check my graphics card driver to see if it needs to be updated?
- How do I switch my license from stand-alone to network or network to stand-alone?
- When performing a Typical installation, what gets installed?
- Why should I specify the Project Folder and Site Folder?
- How do I share the Autodesk Navisworks settings on a site and project basis?
- When should I reinstall the product instead of repairing it?
- When I uninstall my software, what files are left on my system?
- Uninstall and Maintenance Issues
- General Installation Issues
- Quick Start
- Work with Files
- Explore Your Model
- Control Model Appearance and Render Quality
- Review Your Model
- Use Viewpoints
- Play Back Animations
- Work Within a Team
- Share Data
- TimeLiner Playback
- Reference
- Background Settings Dialog Box
- Collision Dialog Box
- Default Collision Dialog Box
- Edit Viewpoint Dialog Box
- File Options Dialog Box
- InfoCenter Settings Dialog Box
- Options Editor Dialog Box
- Glossary
- Index
and then checks the settings in the Project Directory and the Site
Directory. The files in the Project Directory take precedence.
Project Directory Click
to open the Browse for Folder dialog box, and
locate the directory that contains the Autodesk Navisworks settings specific
to a project group.
Site Directory Click to open the Browse for Folder dialog box, and
locate the directory that contains the Autodesk Navisworks settings standard
across the entire project site.
Interface Node
Use the settings in this node to customize Autodesk Navisworks interface.
TIP If you want to restore the default values, click the Defaults button.
Display Units Page
Use this page to customize the units used by Autodesk Navisworks.
Linear Units Use the drop-down list to select the desired linear value. Meters
are used by default.
Angular Units Use the drop-down list to select the desired angular value.
Degrees are used by default.
Decimal Places Specifies the number of decimal places used by units.
Fractional Display Precision Specifies the level of fraction used by units. This
box is enabled for fractional units only.
Selection Page
Use the options on this page to configure the way geometry objects are selected,
and highlighted.
Pick Radius Specifies the radius, in pixels, that an item has to be within in
order for it to be selected.
Resolution Specifies the level of selection used by default.
282 | Chapter 13 Reference