2012

Orbit Tools
Use Classic Orbit Select this check box if you want to switch from the standard
Orbit tool to the classic Autodesk Navisworks Orbit mode on the navigation
bar.
Use Classic Free Orbit (Examine) Select this check box if you want to switch
from the standard Free Orbit tool to the classic Autodesk Navisworks Examine
mode on the navigation bar.
Use Classic Constrained Orbit (Turntable) Select this check box if you want
to switch from the standard Constrained Orbit tool to the classic Autodesk
Navisworks Turntable mode on the navigation bar.
Walk Tool
Use Classic Walk Select this check box if you want to switch from the standard
Walk tool to the classic Autodesk Navisworks Walk mode on the navigation
bar.
Constrain Walk Angle When this check box is selected, the Walk tool will
keep the camera upright while navigating. If this check box is clear, the tool
will allow the camera to roll while navigating (resulting in behavior almost
like the Fly tool).
Use Viewpoint Linear Speed When this check box is selected, the Walk tool
will respect the Viewpoint Linear Speed setting. In this case, the Walk speed
slider will act like a multiplier.
When this check box is clear, the Walk tool will work independently of the
Viewpoint Linear Speed setting, using a fixed value set with the slider.
Walk Speed Sets the speed of the Walk tool from 0.1 (very slow) to 10 (very
fast).
ViewCube Page
Use the options on this page to customize the ViewCube behavior.
Show the ViewCube Indicates whether or not the ViewCube is displayed in
the Scene View.
TIP You can also toggle the ViewCube by clicking View tab ➤ Navigation Aids
panel ➤ ViewCube .
294 | Chapter 13 Reference