Installation guide

operating settings learn routine

™

Many of the operating settings of this unit are programmable. They can be changed whenever necessary through

a computer-based learn routine. To simplify programming, the DEI Bitwriter (P/N 998T) can be used to change

options as well as lock the Learn Routine. If there is no response from the Learn Routine, plug the DEI Bitwriter

into the data port and verify that the Feature Programming is unlocked.

1. Key. Turn the ignition on and then back off. (The H1/9 YELLOW switched ignition input

must be connected.)

2. Choose. Within 10 seconds, press and release the Valet

/Program switch the number of

times corresponding to the feature number you want to program (see the Features Menu

section of this guide). The LED ON settings listed in the Features Menu table are the factory

default settings.

Once the Valet/Program switch has been pressed and released the number of times corre-

sponding to the feature you wish to program, press it once more and hold it. After a

second, the LED will flash to indicate which feature you have accessed. For example, groups

of five flashes would indicate access to Feature 5 (Active/Passive Locking feature). The

horn will also honk five times (if connected).

3. Transmit. The transmitter is used to select the desired setting. As shipped, the unit is con-

figured to the default LED ON settings. Pressing the lock/arm button will set the feature to

the LED ON setting. The LED will light solid (stop flashing) to indicate the setting. The horn

will honk once (if connected). Pressing the unlock/disarm button (on a Standard OEM Style

Configuration transmitter) will change the setting to the LED OFF setting. The LED will turn

off indicating the change and the horn will honk twice (if connected).

4. Release. The Valet

/Program switch can now be released.

For example, to program Feature 1 (Arming Mode) from active to passive, within 10 seconds of turning the igni-

tion off, press and release the Valet®/Program switch once. Then press it again and hold it. The LED will flash in

groups of one and the horn will honk once (if connected). While holding the Valet®/Program switch, press the

unlock/disarm button (on a Standard OEM Style Configuration transmitter). The LED will stop flashing and go out.

The horn will honk twice if connected. Passive arming is now programmed. If that was not the desired setting,

without releasing the Valet®/Program switch, press the lock/arm button on the transmitter. The LED will light

solid and the horn will honk once if connected. Active arming is now programmed. Release the Valet®/Program

button after the correct selection is made.